Anden Industrial Dehumidifier A320 320 Pints / Day 240V

Anden Industrial Dehumidifier 320 Pints / Day 240V

+ CLICK IMAGES TO ZOOM

Anden Industrial Dehumidifier 320 Pints / Day 240V Anden Industrial Dehumidifier 320 Pints / Day 240V Anden Industrial Dehumidifier 320 Pints / Day 240V

Anden Dehumidifiers

$5,875.95

Sorry, this product is temporarily out of stock.

Anden Industrial Dehumidifier A320 320 Pints / Day 240V

The Anden 320 Dehumidifier uses an evaporator coil to drop air temperature before your grow room reaches dew point. Moisture is removed from incoming air and can be drained into a floor drain or outside the grow space. Before air is propelled back into the greenhouse, it is re-heated while passing over a condenser coil. Dehumidification will continue to be active to reach set point, then deactivate until sensor readings determine a need for operation.

The Anden A320V1 Dehumidifier model was developed for precise humidity management to maintain a fixed saturation point. The A320V1 model can also be programmed to circulate air within your grow facility, cutting down on HVAC equipment costs. Dynamic airflow should carry moisture away from plants to prevent fungus, pests and other humidity diseases from establishing in your crops. Free circulating air will also maximize the availability of CO2 around the leaves of your plant. Units can be synced with the Anden 8840 Thermostat for full greenhouse HVAC readings and high tech remote functionality.

Cultivators consistently stress the importance of accuracy in humidity metrics, as unbalanced humidity can cause disease and have a significant impact on nutrient uptake. Commercial horticulture dehumidifiers are distinct from other industrial units by considering the thermodynamics of the greenhouse. Depending on where it is recorded, temperature and humidity can vary greatly. These models are designed to consolidate humidity readings through the use of sensors. Models are equipped with remote sensors that can be placed at plant level to provide accurate monitoring and control.

Anden’s remote sensors allow growers to establish precise relative humidity to determine vapour-pressure deficit and optimize transpiration. It is critical to strike the correct deficit balance as an elevated VPD (over 1.25 kPa) will cause distorted growth, while low VPD (under 0.8 kPA) will limit mineral absorption. As drastic fluctuations in temperature and humidity will also affect plant development, Anden dehumidifiers incorporate a specialized extra sensor that will sample air continuously for three minutes every hour to ensure that desired humidity levels are maintained.

Features
Control: On-Board digital with diagnostics
Air supply orientation: Horizontal
Filter: 20" x 22" x 2" MERV 11
Refrigerant: R410A
Coil type: Copper tube, Aluminum fin with ElectroFin E-coated
Drain connection (requires drain trap): 3/4" FNPT
P-Trap required: Yes (included)
Hanging brackets: included
Warranty: 5 years on all parts including refrigeration system

Included Items
Control: Model A77
Drain fittings: 3/4" MNPT x 3/4" BARB, 3/4" MNPT x 3/4" Female pipe, 3/4" FNPT x 3/4" Female pipe, 3/4" P-Trap
Drain tubing (length, ID): 10' - 3/4" ID
Thermostat wire: 30' 20 gauge 4-wire

Specifications
Capacity(1) PPD at 80°/60%RH: 320
Energy factor(1): 2.9L/kWh - 6.0 pints/kWh
Voltage, phase, frequency: 208-240VAC, 1 phase, 60Hz
Current draw (amps)(1): 11.1
Power (Watts)(1): 2,310
Power cord type and length: SJT, 6-20P, 10ft
Hardwire: Field configurable
Breaker size: 20 amp
CFM: 830
Operating range Temp/RH: 60/50 to 85/80
Dimensions: 32 5/8"W x 24"H x 24 1/4"L
Weight: 180 lbs

(1)Rated capacity and energy factor test done and current draw measured in accordance with AHAM DH-1 2008 at 80°F/60% Rh inlet air at 0.0 ESP.
(2)Total cooling load.

Special Order Item Note: Please note that there are MANY MANY products that we list on this website but do not actively stock in-store. While THC stocks an unbelievably wide and deep range of products, we can't actively carry EVERYTHING, so we list a relatively small (but actually huge) quantity of products that we are generally easily able to order in for you from one or more of our 'regular suppliers' quite quickly. We generally require a deposit for these Special Order items, and we are always eager to help however we're able! Please never hesitate to speak with one of our Shipping, Online Sales, and Customer Service Specialists either at storeATtorontohemp.com or on the phone at 416-920-1980 (follow prompts to 'Shipping' or punch in extension 711 anytime).

Oversized / Heavy Item - Additional shipping charges may apply.

Stock # 39799

All Prices are in Canadian Dollars. We accept these payment methods (and Interac E-Transfer):