Honey Labs Honey Dabber 2 - Quartz W/ Cherry Wood Sleeve
The HoneyDabber II™ is the newest innovation from Honey Labs!
It features all of the value and benifits of its predecessor, with the added capibility of using replacement tips!
Made possible by the use of a medical grade silicone friction mount fitted to the inside of the mouthpiece.
Quickly and easily switch between Titanium or Quartz tips.
Comes with one tip of your choice. This listing is for Quartz
Check out the videos at www.honeydabber.org to see how to use or replace the tips on your Honey Dabber II™
Read and follow all warings and directions for proper use at the bottom of this page prior to using this product.
DO NOT create a complete seal with the tip of your Honey Dabber onto your essential oil. Doing so could make the Honey Dabber act as a straw and may cause you to suck hot essential oil into your mouth and possibly cause you injury or harm. Doing so could also clog the pipe. Honey Labs Llc shall not be held accountable for any harm, injuries, or damages caused by misues of this product or negligence of this warning.
Proper way to use a Honey Dabber is to hold it at a slight angle as you touch it to your essential oil so that you do not create a seal around the tip and cause the Honey Dabber to act as a straw.
Directions for proper use:
Step One:
Remove the patent pending removable wooden sleeve.
Step Two:
Using a butane torch or lighter, apply the flame directly to the end of the exposed titanium, glass, or quartz tip for a few seconds.
Because the thickness of the tubes have thin walls, it will heat up quickly.
4-7 SECONDS IS ALL THAT IS NEEDED. OVERHEATING CAN CAUSE EXCESSIVE HEAT TO TRANSFER INTO THE MOUTHPIECE OR COMPROMISE THE INTEGRITY OF THE GLASS/QUARTS/RUBBER COMPONENTS.
FOR THE TITANIUM TIP, HEAT IT UNTIL YOU SEE THE END START TO GLOW RED. ONCE IT STARTS TO GLOW RED WAIT UNTIL THE REDNESS FADES COMPLETELY BEFORE APPLYING IT TO YOUR ESSENTIAL OIL WAX.
DO NOT POINT FLAME DOWN THE TUBE TOWARDS THE MOUTHPIECE. DOING SO COULD CAUSE THE FLAME TO REACH THE INTERIOR OF THE MOUTHPIECE AND CAUSE THE WOOD, MEDICAL GRADE SILICONE TIP MOUNT, OR RUBBER MOUTHPIECE CAP TO COMBUST.
Step Three:
While inhaling through the wooden mouthpiece, apply the hot tip at a slight angle, as to not make a complete seal around the tip, into your legal Hemp CBD or Tobacco wax.
PLEASE SEE DIAGRAM AND DESCRIPTIONS ABOVE FOR MORE DIRECTION ON HOW TO AND HOW NOT TO APPLY THE HOT TIP TO YOUR WAX.
Step Four:
Carefully replace the patent pending removable wooden sleeve over the hot exposed tip until the magnets clasp.
ALLOW THE DEVICE TO COOL COMPLETELY WITH THE PATENT PENDING REMOVABLE WOODEN SLEEVE SLID OVER THE TIP SHIELDING YOU FROM THE HOT TIP AFTER USE BEFORE USING AGAIN.
REPEATED USE WITHOUT ALLOWING THE DEVICE TO COOL COMPLETELY CAN CAUSE OVERHEATING OF THE INTERIOR COMPONENTS.
Honey Labs LLC shall not be held accountable for any harm, injuries, or damages caused by misuse of this product or negligence of these warnings/directions.
Stock # 25922